» Micra Series

Low-cost starter model for smaller printing volumes
Thermal direct or thermal transfer print
Print width up to 106.6 mm
Serial, parallel and USB port
Optional Ethernet/LAN interface

» Appealing design and compact overall size

The Micra series prints alternatively in thermal direct or thermal transfer mode. The pleasing design inserts itself into different environments. Owing to the amply measured cover label roll and ribbon can be changed simply and fast.

Despite the small size of housing the printer can be equipped with label rolls up to 127 mm (5”) and ribbons with 300 m length. Idle times caused by replacing the expandable material will be reduced and productivity will be increased.

» Cutter Unit Rotation

With the rotary cutter label materials up to a weight of approx.
200 g/m² can be cut. The refit cutter permits single cut and interval cut.

» Cutter Unit Guillotine

The guillotine cutter permits cutting of materials up to a weight of 170 g/m² without any problems. The cutter can be refit without any technical effort. Single cut, interval and final cut are available as operating modes. Activation of a cut can be effected by an external impulse or automatically.

» Label Dispenser Unit

The photocell recognises the label in dispensing position and interrupts the print job. After removing the label manually the next label is printed automatically.

» External Label Unwinder Unit

The unwinder can be used for label rolls up to a diameter of
250 mm. The label winding is optionally inside or outside.

» Interfaces

Moreover the Micra series is equipped with standard serial, parallel and USB connection. In order to integrate the printer into a network an internal Ethernet card is available optionally. Therewith the Micra can be connected to almost all computer systems.